Highway 1 Closes Overnight at Point Sur as Daytime Controls Begin at Torre Canyon
Full overnight closures run through Thursday just north of the Point Sur Lighthouse while crews pull temporary sheet piles from the embankment repair, and a new five-week daytime one-way control near Torre Canyon Bridge began Tuesday, with delays of up to 20 minutes.

Drivers heading south from Carmel on Highway 1 face a full overnight closure at Point Sur through Thursday night and a new daytime bottleneck farther south near Torre Canyon Bridge, in a week when the coast highway is open end to end again but still lined with repair work left by the summer fires.
The Point Sur closure runs from 11 p.m. to 5 a.m. through Thursday, Oct. 15, between Post Mile 54.2 and 55.6, just north of the Point Sur Lighthouse, according to Caltrans District 5. See Monterey, the county's destination marketing organization, carries the same closure window and post miles on its travel alerts page, and AFAR's Oct. 12 update on Big Sur road conditions reports the same overnight schedule.

Crews are removing temporary sheet piles as part of the emergency repair of the Point Sur embankment failure, which began in February after the embankment supporting the southbound lane failed, Caltrans said. The agency advised travelers to avoid the area during the closure hours and warned that residents nearby can expect noise overnight while the work is underway. Message signs are posted in advance of the closed section.
The highway stays open through the area during the day, and once the overnight work is complete the stretch returns to one-way signalized traffic control, according to Caltrans. On Friday night, Oct. 16, one-way traffic control will again be in place from 11 p.m. to 5 a.m., with delays of about 10 minutes, the agency said. AFAR also reported the Friday one-way control in its road update.

A second work zone took effect on Tuesday, Oct. 13, near Torre Canyon Bridge, where travelers will encounter one-way traffic control from 7 a.m. to 7 p.m., Monday through Saturday, for approximately five weeks, Caltrans announced in an Oct. 13 release. Crews will remove rocks and brush from the slopes above the highway as part of post-fire slope stabilization work. Delays may reach 20 minutes, according to both Caltrans and See Monterey's current travel alert, and signs will direct drivers in advance of the controlled section.
The work follows the reopening of Highway 1 through Big Sur, which officials lifted by Oct. 9 after the Plaskett Fire closure forced weeks of inland detours between Carmel and Cambria, AFAR reported. The Timber and Plaskett fires together burned more than 55,000 acres. As of Oct. 12, the Timber Fire stood at 25,352 acres and 97 percent contained, and the Plaskett Fire at roughly 30,000 acres and fully contained, according to the Cal Fire figures AFAR cited. Burned slopes can stay vulnerable to rockfall, erosion and debris flows long after the flames are out, which is why stabilization work along the corridor is continuing into the fall.

Closer to home, the County of Monterey's resurfacing of Carmel Valley Road between Carmel Rancho Boulevard and Via Petra continues through the end of October, with lane closures and one-lane traffic control during work periods, according to the county and See Monterey's current alert. Day work runs from 8:30 a.m. to 3:30 p.m., and overnight paving runs from 7 p.m. to 5:30 a.m. The project covers roughly 1.5 miles at the mouth of Carmel Valley and began on June 29, according to Monterey County NOW and the county's project release.
Caltrans advises travelers to check its QuickMap service for real-time road conditions before driving the coast, and both the agency and See Monterey direct drivers to District 5's social channels for updates as the schedules change.
We correct errors promptly and note them here. Send corrections through the contact form on our contact page.


